Note: the small white button close to the red USB plug in the picture above
The small button on the Raspberry Pi Pico is called the BOOTSEL Button. It's used to enter the bootloader mode, which is necessary for flashing new firmware onto the Pico. When connected to a computer via USB while holding the BOOTSEL button, the Pico will appear as a USB mass storage device, allowing you to drag and drop the firmware (usually a .UF2 file) onto it
How to Update Your Firmware
Step 1: Get the Firmware File
Go to the Contact page on this website.
Send me an email requesting the firmware.
I will reply and email you an attached file ending in .UF2. Save this file to your computer's desktop.
Step 2: Prepare Your Equipment
What you need: A USB to USB-C cable.
The setup: Your computer must be turned on. You can leave the Raspberry Pi Pico plugged into the CPU board, or you can unplug it.
Locate the button: Find the small white BOOTSEL button on the Raspberry Pi Pico (right next to the red USB plug)
Step 3: Connect and Flash the .UF2 firmware file (Follow Carefully!)
Press and HOLD the small white BOOTSEL button down. Do not let go yet!
Plug the USB cable into your computer and into the Raspberry Pi Pico while still holding the button.
Release the button once the cable is fully plugged in.
Watch your computer screen. A new folder window will automatically pop up on your computer. (If a small menu asks you what to do instead, click "Open folder to view files").
Drag and drop the .UF2 firmware file you received via email directly into that open folder
All Done! The file will copy over, the folder window will automatically disappear from your screen, and the Pico will reboot itself with the new firmware running. You can now use your radio.
Old Firmware update procedure: Current version is V150 (Old procedure follows until now one above is verified as user friendly)
The firmware can obtained by emailing me and I will email you the .UF2 file. Find the email address on the Contact page. There are two ways of installing / updating the firmware:
The first is to plug the PC computer USB directly into the Raspberry Pi Pico2 directly. This can be done either with the Pi Pico plugged into the CPU board or not. For this a USB - USB type C cable is required.
Press and hold the small white button on the Pi Pico (BOOTSEL Button) and plug in the USB cable into the PC and Pi Pico. The PC should make a chime acknowledgment sound (If the sound is on). Either: An options pop up will ask what to do, if this happens select 'Open folder to view files'. This window might also automatically open with no need to select it.
When this pop-up window appears the PI Pico is acting as a memory stick. There will be two files showing: INFO_UF2.TXT and INDEX.HTM
Drag and drop the UF2 Firmware File sent to you into the pop-up folder, just as if you were saving a file to a memory stick.
The .UF2 file (firmware) will automatically download to the Pi Pico2 and then install it automatically. Next the Pi Picp2 will do a reset and run the new firmware.
The folder will then disappear from the PC screen.
All done. It is as simple as that.